This sample shows how to send signals to a bTicino MyHome system, or any system that supports the OpenWebNet protocol.
Currently only lights and shutters are supported, but extensions shouldn't be so hard.
You need an ethernet compatible device that supports the OpenWebNet protocol, e.g. the MH200
You also need to make sure that the http server (i.e. the device where you run the MyURemote server) has an ip address in the allowed ip range.
Any device with an ip address in this range can send commands to the system without entering a password.
This can only be configured through the software delivered with the device.
Click here for sample specific documentation
Click here for information about how to setup your OpenWebNet gateway.
MyHome ip address | |
MyHome port | (fixed) |
Light address | On | Off |
---|---|---|
Shutter address | Up | Stop | Down |
---|---|---|---|